VEX100

MEKANISK YDEEVNE: In accordance with ds/en 1886 and certified by Eurovent

In accordance with ds/en 1886 and certified by Eurovent:

• Strength of unit housing: D1 (M)
• Tightness at negative pressure of -400 Pa: L1 (M)
• Tightness at positive pressure of +700 Pa: L1 (M)
• Filter bypass leakage: F9 at negative and positive pressure
• Thermal transmittance: T2 (M)
• Thermal bridging factor: TB3

The cabinets are made of Aluzinc AZ185 class C4 according to EN/ISO 12 944-2 and insulated with 50 mm mineral wool. This results in a low noise level to the surroundings/setup room.

The panel construction minimizes the formation of thermal bridges in the unit.

The motor sections are mounted in vibration dampers, which means less noise and vibration in the ducts, and there is no need to install flexible connections between the unit and the duct system.

The motor sections are retractable for easier service.

The motors are EC type with very high efficiency, meeting the requirements of the EcoDesign directive.

The aggregate is equipped with EXHAUSTO's EXstream impeller, one of the market's leading impellers in terms of low energy consumption and low noise level.

The easily accessible connection box with built-in supply isolator and circuit breakers ensures easy access for connection and adjustment.

The filter panels are easy to replace and can be ordered as filter class Coarse 85% (M5) or ePM1 55% (F7) according to ISO 16890.

VEX100-serien leveres med integreret eftervarmeflade, enten til vand eller el

VEX140 - VEX160:

Montagesokkel med fødder, der kan justeres i højden - 130 - 160 mm.

Montagesoklen er standard for VEX170.

VEX100 IS AVAILABLE AS A SPLIT VERSION.

With some projects, limited space means that internal transport of the air handling unit is difficult or impossible. This is why the VEX100 is available as a split version. It means that the air handling unit can be assembled and tested at the factory as normal – just without sealant. The air handling unit can therefore be easily taken apart at the installation site, transported as single sections, assembled, sealed and commissioned.

The table below shows the dimensions of the largest section (crossflow heat exchanger) and largest cabinet section, so that it can easily be determined whether there is sufficient space to allow internal transport.